Increment File Revision

Modificado/a el: septiembre 04,2020  
Evaluación
Descargas: 84  
Comentarios

Especificaciones

Descargas:84
Descripción:Easily increment your custom property Revision, create new versions of files and move old to an !ARCHIVE folder
    Condición previa: Our file naming system always contains "REV X" where X can range from Z1-Z# (for prelimnary) followed by A-YY. Our first version of a file would be Z1. Ideally there is a SLDDRW with same exact filename and a PDF of that. The Part/Assembly must have the custom property, "Revision" PDF file of drawing and SLDDRW should be closed There is a table built in going from IR, A, B...H (skip I), J, K, (skip L) etc.
  Condición posterior: In each drawing folder there is another folder named "!ARCHIVE" otherwise it will be created If the Revision is Z1, it will ask to release. If Yes, Revision is changed to IR otherwise it is incremented to Z2. The slddrw and the PDF are copied and sent to the !ARCHIVE folder and new versions are created next to the model file with the new Revision number/letter.
Versión de SOLIDWORKS: Unknown
Lenguaje de programación: SW_VBA

 


Las macros pueden contener virus y otros riesgos de seguridad. SOLIDWORKS Corporation no ha comprobado que las macros que aparecen en este sitio son seguras y proceden de una fuente fiable.

Descargue la macro de SOLIDWORKS.

 

(Inicio de sesión necesario)  

Contribuyente
Otras contribuciones de este usuario

Piezas y ensamblajes

 

 

 

Macros
Abraham Azar III

Usuario desde: 29/05/2009
Título: Engineer
 
Aptitudes:
Design, Modeling, Illustration, Analysis
Intereses:
Manufacturing, Research & Development, Experiments
 
  Informar sobre un usuario que tiene errores
Informar sobre comentarios inapropiados