3d printed part. Goes under Z scale to accomodate draft angle on column. Actually I missed slightly but not enough to bother to remove them & try again.See also the Z scale slider brkt & the Y scale assy. Photos available at Thingaverse under stillyriver

3d printed part to mount Z scale slider to G0704 mill. Photos available at Thingaverse under stillyriver. Basically the scale is attached to the column & this part reaches over it to attach slider to movable head. See also the shim for under the scale to pick up the draft angle. See also the Y scale mounts.

3d printed part for getting steam into poly bag tubing when steam bending wood. Barb sized for 1/2" ID hose. Could be scaled in slicer for other ID hoses. Push thru small round hole in plastic about half it's dia for a snug fit. That retaining washer proved to be of no value, don't bother printing it.

3d printed part used to keep oxy-act hoses from sliding down handle of the cart.

3d printed part to mount Dremel flex tool to lathe tool post in vertical position.

3d printed part to mount Dremel flex tool to lathe toolpost in horizontal position.

Wilian oliveira siqueira

TREINO.

Gainta

G113MF is a sealed case in natural aluminum color, made from ADC-10 (JIS) aluminum alloy. Provides protection against ingress of dust and moisture according to IP65 standard. Overall dimensions are: length 115mm, width 90mm and height 55mm. On the inner surface of the case there are cast racks for horizontal and guides for vertical placement of printed circuit boards.

No proporcionado

No proporcionado