No proporcionado

HT396R-6P

HT396R-6P 3.96mm 凯峰 接插件 连接器

KF ??

HT396 3.96mm 弯针 接插件 PCB

Javier inventos

Sirve para censar el nivel exacto de un tanque pequeño máximo de 4m3 de capacidad

3d printed part. Goes under Z scale to accomodate draft angle on column. Actually I missed slightly but not enough to bother to remove them & try again.See also the Z scale slider brkt & the Y scale assy. Photos available at Thingaverse under stillyriver

3d printed part to mount Z scale slider to G0704 mill. Photos available at Thingaverse under stillyriver. Basically the scale is attached to the column & this part reaches over it to attach slider to movable head. See also the shim for under the scale to pick up the draft angle. See also the Y scale mounts.

3d printed part for getting steam into poly bag tubing when steam bending wood. Barb sized for 1/2" ID hose. Could be scaled in slicer for other ID hoses. Push thru small round hole in plastic about half it's dia for a snug fit. That retaining washer proved to be of no value, don't bother printing it.

3d printed part used to keep oxy-act hoses from sliding down handle of the cart.

3d printed part to mount Dremel flex tool to lathe tool post in vertical position.

3d printed part to mount Dremel flex tool to lathe toolpost in horizontal position.