http://www.meder.com/reed_sensor_mk02_uk.html

These reed proximity switches operate when in the presence of magnetically conductive material. Instead of an actuating magnet, only a simple piece of iron is required to operate the sensor from the f

http://meder.com/reed-sensor-mk12-uk.html

MK12 sensors are magnetically operated Reed Sensors designed for screw mounting. The larger casing permits the use of higher rating switches. The sensor should be mounted on a fixed surface with the a

http://meder.com/reed-sensor-mk21-uk.html

MK21 sensors are magnetically operated Reed proximity switches designed for screw mounting. The sensor should be mounted on a fixed surface with the actuating magnet on the moving surface. Introduction or removal of the magnetic field determines the closing and opening of the Reed Switch. Leads are Teflon coated. Designed for extreme environment. High temperaturs, 150 °C, resistant to water, fuels, oils, ink and most acids.

http://meder.com/dip-reed-relay-uk.html

The DIP Series is a very compact design having a low profile package and a high profile package. This series is compatible with all current brand DIP relays.

http://meder.com/li-relay_en.html

The LI series offers the maximum distance between coil and switch in the smallest possible housing.

http://meder.com/h-relay_uk.html

High voltage relay having up to 10 kVDC switching and 15 kVDC breakdown voltage contact to coil. Reliable switching of high voltages up to 10000 V. The special open construction provides very high insulation values up to 15000 VDC and 1000 Gigaohm between coil and contact. A breakdown voltage of up to 15000 Volt over the open switch is achieved through the use of vacuum reed switches.

http://meder.com/reed-sensor-mk20-1-uk.html?&tx_jppageteaser_pi1[backId]=337

MK20/1 proximity sensors are magnetically operated Reed Switches in a cylindrical module, fitted with interconnect cable. The sensor should be mounted on a fixed surface with the actuating magnet on the moving surface. Introduction or removal of the magnetic field determines the closing and opening of the Reed Switch.

http://meder.com/reed-sensor-mk14-uk.html

MK14 proximity sensors are magnetically operated Reed switches in a 4.0 mm diameter miniature housing, fitted with interconnect cable. The sensor should be mounted on a fixed surface with the actuating magnet on the moving surface. Introduction or removal of the magnetic field determines the closing and opening of the Reed Switch.

http://meder.com/reed-sensor-mk07-uk.html

MK07 sensors are magnetically operated Reed proximity switches in a cylindrical form with an 8 x 0.75 mm thread and connecting cable or coupler. The sensor can be screwed directly into a work piece or mounted using a nut with the actuating magnet on the moving surface. The MK07 series is compatible with several inductive and magnetic proximity sensors.

http://meder.com/reed-sensor-mk22-uk.html

MK22-Sensors ar magnetically operated, over moulded Reed proximity Switches for SMD mounting.Lead design 1: Flat, straight leads for PCB slot mounting.Lead design 2: Flat, bent SMD leads (15.6 mm length)Lead design 3: Flat, bent SMD leads (19.5 mm length)Magnet force and position magnet/sensor determine Pull-In and Drop-Out point. The sensors are supplied taped & reeled according to IEC 286/part 3 suitable for auto-placement.